Blower Motor Relay: Service and Repair

BLOWER MOTOR RELAY REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: The blower motor relay that is used on the M/L van is an integral part of the blower motor resistor and can not be serviced separately from the resistor.




1. Remove the air cleaner.
2. Remove the windshield washers and the coolant reservoir for access.
3. Disconnect the electrical connectors.
4. Remove the screws from the blower motor resistor.
5. Remove the blower motor resistor (4).

INSTALLATION PROCEDURE




1. Install the blower motor resistor (4).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the screws to the blower motor resistor.

Tighten
Tighten the blower motor resistor screws to 2 N.m (18 lb in).

3. Install the windshield washers and the coolant reservoir for access.
4. Connect the electrical connectors.
5. Inspect the circuit for proper operation.
6. Install the air cleaner.