Crankshaft Position Timing Ring: Service and Repair

Removal Procedure

^ Tools Required
- J 41371 Reluctor Wheel Remover

1. Disconnect the battery negative cable from the battery. Refer to Battery Cable Replacement (Battery Cable Negative) in Starting and Charging.
2. Remove the crankshaft balancer from the crankshaft. R
3. Remove the water pump from the engine block.
4. Remove the engine front cover from the engine block.





5. Use the J 41371 to remove the crankshaft position reluctor ring from the crankshaft.

Installation Procedure

^ Tools Required
- J 22102 Crankshaft Sprocket Installer

Important: Replace the crankshaft position sensor whenever the crankshaft position reluctor ring is replaced





1. Use the J 22102 to install the crankshaft position reluctor ring on to the crankshaft.





2. Install the engine front cover to the engine block.
3. Install the water pump to the engine block.
4. Install the crankshaft balancer to the crankshaft.
5. Connect the battery negative cable to the battery.
6. Fill the cooling system.