35. Piston and Connecting Rod Disassemble

^ Tools Required
- J 24086-C Piston Pin Remover/Installer





1. Using piston ring pliers, remove the piston rings from the piston.





2. Select fork adapter J 24086-920A and install into the press.
3. Install the piston and connecting rod assembly onto the J24086-C.

NOTICE: After the installer hub bottoms on the support assembly, do not exceed 35 000 kPa (5,000 psi) pressure, this could cause damage to the tool.

4. Use the J 24086-C in order to remove the piston pin from the piston and connecting rod assembly.
5. The piston and pin are a matched set and are not to be serviced separately. Mark, sort, or organize the piston to the matching piston pin.