B1398

DTC B1398 Device Voltage Reference Out #1 CKT High:

CIRCUIT DESCRIPTION
The Body Control Module (BCM) provides a constant output reference voltage (5 volts) for the proper operation of the ambient light sensor. The constant output reference voltage supply ensures that variations in the output signal of the ambient light sensor is due to changes of the sensor rather than variations in the voltage supply. The BCM monitors the constant output reference voltage (5 volts) and sets a DTC when the output is not within the expected range (4.75-5.25 volts).

CONDITIONS FOR SETTING THE DTC
^ When the ignition switch in the RUN position, the 5 volt reference output CKT 705 is greater than 5.25 volts (shorted to battery).
^ The system voltage must be between 9.0-16.0 volts.
^ The above conditions must be met for 0.5 seconds.

Action Taken When The DTC Sets
The Daytime Running Lamps (DRL) feature will not operate.

CONDITIONS FOR CLEARING THE MIL/DTC
^ A DTC will clear immediately after the condition for setting the fault is corrected.
^ A history DTC will clear after 100 consecutive ignition cycles without a fault present.
^ Use a scan tool in order to clear history and current DTCs.

DIAGNOSTIC AIDS
^ Always diagnose the first DTC listed on the scan tool.
^ The scan tool must display DTC B1398 as a current code before performing diagnostics.
^ Perform a visual inspection for loose or poor connections at all related components.
^ Refer to Intermittents and Poor Connections in Diagrams.

TEST DESCRIPTION
Number(s) below refer to the step number(s) on the Diagnostic Table.
2. This step determines if the BCM 5 volt reference is defective or if CKT 705 is shorted to battery. By disconnecting the BCM connector, other DTCs will set.