HVAC System - Manual
Control Assembly ReplacementREMOVAL PROCEDURE
1. Remove the instrument cluster trim plate.
2. Remove the retaining screw from the left edge of the heater control assembly.
3. Pivot the heater control assembly from the instrument panel.
4. Pull the heater control assembly out of the instrument panel in order to access the vacuum and the electrical connectors.
Heater Control Vacuum And Electrical Harness:
5. Remove the following items from the heater control assembly:
^ The electrical connectors
^ The vacuum connectors
INSTALLATION PROCEDURE
Heater Control Vacuum And Electrical Harness:
1. Install the following items to the control assembly:
^ The vacuum connectors
^ The electrical connectors
2. Align the tab on the heater control assembly with the slot in the instrument panel.
3. Pivot the heater control assembly into the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screw in order to retain the left edge of the heater control assembly.
Tighten
Tighten the screw in order to retain the left edge of the heater control assembly to 2 N.m (18 lb in).
5. Install the instrument cluster trim plate.