Power Door Lock Actuator: Service and Repair

Lock Actuator Replacement - Door




REMOVAL PROCEDURE
1. Remove the trim panel.
2. Use a sharp bladed tool in order to separate the water deflector at the perforations. Refer to Water Deflector Replacement - Front Door. Service and Repair
3. Remove the power door lock actuator in order to remove the remote lever rod.
4. Disconnect the power door lock actuator wiring harness.
5. Use a 6 mm (1/4 in) drill bit in order to remove the actuator to door rivets.
6. Remove the actuator from the door.

INSTALLATION PROCEDURE
1. Install the actuator to the door.

IMPORTANT: Install new plastic retainer clips whenever the lock rods are removed.

2. Install the actuator to door rivets.
3. Connect the power door lock actuator wiring harness.
4. Install the power door lock actuator to the remote lever rod.
5. Install the water deflector.
6. Install the trim panel.