Sliding Door Handle: Service and Repair

REMOVAL PROCEDURE
1. Remove the trim panel.
2. Remove the water deflector.
3. Remove the lock control.
4. Remove the lock rods from the handle (1).
5. Remove the outside handle nuts (2).
6. Remove the outside handle and gasket from the door.

INSTALLATION PROCEDURE
1. Install the outside handle and gasket to the door.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the outside handle nuts (2).

Tighten
Tighten the outside handle nuts to 6 N.m (50 lb in).

3. Install the lock rods to the handle (1).
4. Install the lock control.
5. Install the water deflector.
6. Install the trim panel.