Oil Pump, Pump Screen and Deflector Installation

1. Inspect for properly installed oil pump locating pins.

IMPORTANT: During assembly, install a NEW oil pump driveshaft retainer. Slightly heat retainer above room temperature for ease of installation onto the oil pump driveshaft.





2. Assemble the oil pump, driveshaft, and a NEW retainer.
3. Install the oil pump assembly.
Position the oil pump onto the locating pins.

NOTICE: Refer to Fastener Notice in Service Precautions.

4. Install the bolt attaching the oil pump to the rear crankshaft bearing cap.
Tighten the oil pump bolt to 88 Nm (65 ft. lbs.).