Vehicle Speed Sensor (NV 4500)

REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lift Points.
2. Support the vehicle with safety stands.





3. Disconnect the electrical connector from the vehicle speed sensor assembly.
4. Place a suitable container under the transmission in order to catch the fluid.





5. Remove the following parts:
5.1. One bolt
5.2. The vehicle speed sensor
5.3. The O-ring seal

INSTALLATION PROCEDURE
1. Coat a new O-ring seal with a thin film of transmission fluid. Use Castrol Syntorq GL-4 Transmission Fluid or the equivalent.





2. Install the following parts:
2.1. The O-ring on the vehicle speed sensor assembly
2.2. The vehicle speed sensor assembly
2.3. One bolt
- Tighten the bolt to 22 Nm (16 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





3. Install the electrical connector on the vehicle speed sensor assembly.
4. Remove the safety stands.
5. Lower the vehicle.
6. Check the transmission fluid level.