OFF-ON-R/A Switch

The OFF-ON-R/A (Resume/Accelerate) slide switch, located on the multifunction switch, controls four functions.

The OFF/ON Function
When the OFF-ON-R/A switch is in the OFF position the system cannot be engaged. When the switch is in the ON position the system may be engaged at any speed above approximately 40 km/h (25 mph).
The accelerator may be depressed at any time to override the cruise control system. Release of the accelerator will return the vehicle to the previously set cruise speed.

The Resume Function
If the cruise control system has been disengaged by depressing the brake or clutch pedal, it may be reactivated by momentarily sliding the OFF-ON-R/A switch to the R/A position. This will cause the vehicle to accelerate to the previously set speed and cruise at that speed. The resume function will not work if the OFF-ON-R/A switch has been moved to the OFF position or the ignition switch has been cycled since the last time the cruise control was active or the vehicle speed is below the low speed lockout of 40 km/h (25 mph).

The Accelerate Function
By sliding the OFF-ON-R/A switch to the R/A position and holding it, the vehicle will accelerate until the switch is released. The cruise control must be engaged and operating and the vehicle speed must be above the low speed lockout 40 km/h (25 mph) for this function to operate.

The TAP UP Function
For this function to operate, the cruise control must be engaged and operating. "Tapping up" is done by sliding the OFF-ON-R/A switch to the R/A position and immediately releasing it, or "tapping" the switch. Do not hold the switch in the R/A position or the system will revert to the accelerate mode. "Tap up" is a function in which cruise speed can be increased by 1.6 km/h (1 mph) increments (one tap = 1.6 km/h or 1 mph increase). The system cannot "tap up" beyond the vehicle's maximum speed.