C0052

DTC C0052 Rear Dump Solenoid Circuit Open:

Dump Solenoid Circuit Schematic:

CIRCUIT DESCRIPTION
When the REAR dump solenoid is needed (see Antilock Brake System, Description and Operation) the Electronic Brake Control Module (EBCM) will ground the solenoid circuit to energize the coil within the solenoid. This will open the dump valve by the magnetic force created by the solenoid coil.

CONDITIONS FOR SETTING THE DTC
^ ABS bulb check complete
^ Low voltage on EBCM solenoid driver circuit when expected to be high (solenoid not energized)

ACTION TAKEN WHEN THE DTC SETS
^ ANTILOCK indicator lamp is illuminated
^ ABS is disabled

NOTE: DTC C0052 is an Ignition Latched Diagnostic Trouble Codes (DTC) which indicates the above is true until the ignition is turned to OFF (even if the cause of the DTC is intermittent).

DIAGNOSTIC AIDS
DTC C0052 is usually set by an open solenoid coil within the EBCM. The REAR dump solenoid is located within the Brake Pressure Modular Valve (BPMV) and is not serviceable. If the test does not repair the DTC the EBCM must be replaced.
If DTC C0052 is set with other DTCs check for a poor EBCM ground or poor EBCM power feed.

TEST DESCRIPTION
The numbers below refer to the numbers on the diagnostic chart.
2. Inspect EBCM 2-way harness connector for damage.
3. Check EBCM power and ground circuits.