B1014

When measurements are requested in this table, use J 39200 Digital Multimeter with correct terminal adapter from J 35616-A Connector Test Adapter Kit. When a check for proper connection is requested, refer to Intermittents and Poor Connections in Diagrams. When a wire, connector or terminal repair is requested, use J 38125-A Terminal Repair Kit and refer to Wiring Repair. SIR Wiring Repair

CIRCUIT DESCRIPTION
The inflatable restraint Diagnostic Energy Reserve Module (DERM) monitors the voltage at the Driver Source Sense terminal A5, the Driver Side High terminal B9, and the Driver Side Low terminal B8 during the Continuous Monitoring tests. When all voltages measure simultaneously below a specified value for 500 milliseconds, the DERM sets DTC B1014.

CONDITIONS FOR SETTING THE DTC
The DTC sets when the voltages at terminals A5, B9, and B8 of the DERM harness connector measure simultaneously below a specified value for 500 milliseconds.

ACTION TAKEN WHEN THE DTC SETS
The DERM turns on the AIR BAG warning lamp and sets a diagnostic trouble code.

CONDITIONS FOR CLEARING THE DTC
The DTC clears when the voltage at terminals A5, B9, and B8 of the DERM harness connector measures above a specified value for 500 milliseconds.

DIAGNOSTIC AIDS
It is highly unlikely that an intermittent condition has set this diagnostic trouble code as this would require a poor connection at the terminals A and B or at the terminals C and D of the inflatable restraint arming sensor.

TEST DESCRIPTION
Refer to step numbers on the diagnostic table.
1. Start at the SIR Diagnostic System Check for all diagnosis.
2. This test checks for a situation which prevents a proper connection of the inflatable restraint arming sensor jumper harness electrical connector.
3. This test checks for a situation which prevents a proper connection of the inflatable restraint arming sensor to the SIR wiring harness.