Window Regulator Handle

Window Regulator Handle & Bearing Plate:

Tool Required:
J 9886-01 Door Handle Remover

Remove or Disconnect

1. Window regulator handle from vehicle.
A. Insert J 9886-01 between the handle and bearing plate.
B. Align the tool and push to disengage the clip.
C. Pull the handle from door.
2. Bearing plate.

Install or Connect

1. Bearing plate to door.
2. Window regulator handle.
A. Raise window.
B. Install the clip onto the handle.
C. Insert handle onto window regulator shaft so the handle is pointing toward the front of the door.
D. Push on the handle until the clip engages window regulator shaft.