Assemble

^ Tool Required
- J 8062 Valve Spring Compressor, Or Equivalent

1. Lubricate the valve stems with clean engine oil.
2. Insert the valves into their proper location.
3. Install the oil seals over the valve stems.
4. Install the rotators.
5. Install the valve springs.





6. Install the caps using the following procedure:
(1) Compress the valve spring using valve spring compressor. Compress the spring enough in order to clearly see the valve stem grooves.
(2) Apply a small amount of grease to the area of the upper valve keys using grease to hold the keys in place. Make sure that the keys seat properly in the valve stem grooves.
(3) Release the compressor tool. Make sure the valve keys stay in place.
(4) Repeat the preceding steps on the remaining valves.





7. Measure the installed height of each valve spring using the following procedure:
(1) Use a narrow, thin scale. A cutaway scale may be helpful,
(2) Measure from the cylinder head spring seat to the top of the cap.

NOTE: Never shim the spring so as to give an installed height under the specified amount.

If this measurement exceeds the amount given in the specifications, Install the valve spring seat shims of The sufficient thickness between the rotator and the cylinder head in order to give the desired measurement.
8. Install the coolant temperature gauge sensor in the right cylinder head.
^ Tighten the sensor to 20 Nm (15 ft lbs.).