Case Porosity Repair

Leak Inspection Points:

Legend

(1) Bottom Pan Gasket

(2) Electrical Connector Seal

(3) Vent

(4) Line Pressure Plug

(5) Extension to Case Seal

(6) Manual Shaft Seal

(7) Speed Sensor Seal

(8) Extension to Case Seal

(9) Extension Oil Seal

(10) Converter

(11) Oil Pump Seal

(12) Oil Pump to Case Seal

(13) Oil Fill Tube Seal

(14) Servo Cover Seal

(15) Transmission Case

(16) Cooler Connectors
Case Porosity Repair

1. Clean the leak area with solvent.

2. Allow the area to air dry.

Caution: Epoxy adhesive may cause skin irritations and eye damage. Read and follow all In formation on the container label as provided by the manufacturer.

3. Mix a sufficient amount of epoxy adhesive, P/N 1052533, or equivalent.

Follow the manufacturer's recommendations.

4. While the transmission case is hot, apply the epoxy adhesive with a clean, dry soldering acid brush.

5. Allow the epoxy adhesive to cure for three hours before starting the engine.

6. Repeat the fluid leak diagnosis procedures in order to determine if the leak is fixed.