Cylinder Head Assemble
ASSEMBLY1. Clean the valve spring seat area.
2. Install the valve (5 or 6) into the proper port.
NOTE: In order for tool valve stem oil seal installer to work properly, the valve is installed into the cylinder head.
3. Lubricate guide and valve stem oil seal (3) with clean engine oil.
NOTE: Install the valve stem oil seal (3) onto the valve stem (5 or 6). Push the seal down until the seal contacts the valve guide (2).
4. Valve stem oil seal alignment onto the valve guide is critical.
NOTE: A correctly installed seal should not bottom against the valve guide. There should be a 1-2 mm (0.03937-0.07874 inch) gap (2) between the bottom edge of the seal (5) and the valve guide (4).
5. Place the valve stem oil seal installer (J 42073) over the valve stem and oil seal. Lightly tap on the J 42073 until the tool bottoms out against the valve spring seat.
6. Install the valve spring (4).
7. Install the cap (2) on the valve stem (5 or 6).
8. Use the valve spring compressor in order to compress the valve spring.
9. Install the valve stem keys (1).
a. Use grease to hold the keys in place while disconnecting the valve spring compressor.
b. Make sure that the keys seat properly in the upper groove of the valve stem.
c. Tap the end of the stem with a plastic faced hammer in order to seat the keys if necessary.
10. Measure the valve spring installed height from the valve spring seat to the locating surface on the cap.