Front Housing Assembly

Assemble (Figures 38, 39, and 40)

Tools Required:
J 36183 Input Shaft Press Tube with Cap
J 36184 Adapter Press Tube Reducer
J 36510 Clutch Fork Pivot Remover/Installer
J 36507 Detent Bushing Remover and Installer
J 36511 Oil Fill Plug Hex Bit (17 mm)
J 36798-1 Shift Shaft Bushing Installing Tool
J 36190 Drive Handle





1. Press in bearing (216) until snap ring is seated using J 36183, J 36184, and hydraulic press.
2. Shift shaft front housing bushings (228) using J 36798-1 and J 36190 (figure 38).





3. Clutch fork pivot assembly (21 9) using J 36510 and J 36190 (figure 39).





4. Two detent plunger bushings (242), using J 36507 (figure 40).

A. Install the first bushing until the second scribe mark on the tool is aligned with the housing.
B. Install the second bushing until the first scribe mark on the tool is aligned with the housing.

5. Breather assembly (223).

NOTICE:
Refer to "Notice" at the beginning of this bulletin.

6. Oil fill plug (222) and oil drain plug (225) using J 36511 (figure 27).

^ Apply pipe sealant with Teflon(TM) GM P/N 1050280 or equivalent to the threads.

Tighten

^ Drain plug to 60 N-m (44 lbs.ft.).