Ignition Coil: Service and Repair

REMOVE OR DISCONNECT
NOTE Make sure ignition switch is "OFF".
- Wiring connectors at side of the coil.
- Coil to distributor lead at coil.
- Nuts or screws holding coil bracket and coil to engine.
- Coil bracket and coil.
- Drill and punch out rivets holding coil to coil bracket.
- Coil from coil bracket.

INSTALL OR CONNECT
- Coil to coil bracket with screws.
- Coil and coil bracket to engine. Tighten screws to 22 N-m (16 lb. ft.).
- Distributor lead to coil .
- Wiring connectors to the coil.