Fuel Filter: Service and Repair

Fuel Filter Location On Carburetor:

REPLACEMENT

1. Disconnect fuel line connections at fuel inlet filter nut.
2. Remove fuel inlet filter nut from carburetor.
3. Remove filter and spring.
4. If removed, install check valve in fuel filter inlet filter. The inlet check valve must be installed in the filter to meet motor vehicle safety requirements for rollover. New replacement filters must include the check valve.
5. Install fuel inlet filter spring, filter, and check valve assembly in carburetor. Check valve end of filter faces toward fuel line. Ribs on closed end of filter element prevent filter from being installed incorrectly unless forced.
6. Install nut in carburetor. Tighten nut to 24 Nm (18 ft lbs).
7. Install fuel line and tighten connections.
8. Start engine and check for leaks.