Rear Compartment Lid Emblem and Nameplate Replacement (V8)

Rear Compartment Lid Emblem and Nameplate Replacement (V8)

Tools Required

J 25070 Heat Gun


Removal Procedure





1. When replacing an emblem/nameplate, do the following:

1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.

2. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070 .
3. Apply the heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.

Notice: Refer to Exterior Trim Emblem Removal Notice .

4. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.



Installation Procedure

1. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).

Important: Do not touch the adhesive backing on the emblem/nameplate.


2. Remove the protective liner from the back of the emblem/nameplate.
3. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.




4. Position the V8 Northstar emblem (1) on the driver side:

* To the left side of the rear compartment lid
* (a) 67 mm (2.6 in) from the left edge of the rear compartment lid
* (b) 86 mm (3.4 in) from the bottom edge of the rear compartment lid

5. Position the XLR emblem (2) on the passenger side:

* To the right side of the rear compartment lid
* (a) 60 mm (2.4 in) from the right edge of the rear compartment lid
* (b) 86 mm (3.4 in) from the bottom edge of the rear compartment lid

6. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
7. Remove the protective tape from the mounting surface.