Auxiliary Engine Oil Cooler Replacement

Auxiliary Engine Oil Cooler Replacement

Removal Procedure

1. Raise and support the vehicle.
2. Remove the left lower front bumper close out panel.




3. Install oil drain pan under the vehicle.
4. Remove the engine oil cooler hose/pipe from the external oil cooler.




5. Remove the external engine oil cooler retaining bolts.
6. Remove the external engine oil cooler.
7. Remove and discard all engine oil cooler hose/pipe seals.

Installation Procedure




1. Install new engine oil cooler hose/pipe seals.
2. Install the external engine oil cooler.

Notice: Refer to Fastener Notice.

3. Install the external engine oil cooler retaining bolts.

Tighten the bolts to 10 N.m (89 lb in).





Important: The quick connect fitting must be pushed on and then pulled back to verify proper connector engagement.

4. Install the engine oil cooler hose/pipes to the external oil cooler.
5. Remove the oil drain pan from under the vehicle.
6. Install the left lower front bumper close out panel.
7. Refill the engine with oil and check for leaks.