Water Pump Pulley Replacement

Water Pump Pulley Replacement

Tools Required
* J 38825 Power Steering and Water Pump Pulley Remover
* J 38823 Water Pump Pulley Installer

Removal Procedure




1. Release the outer water pump drive belt tensioner and remove the drive belt from the drive pulley.
2. Remove the end cap from the intake camshaft.




3. Remove the water pump drive pulley from the intake camshaft using the J 38825.

Installation Procedure




1. Place the water pump drive pulley in position on the intake camshaft.




2. Install the water pump pulley onto the intake camshaft using the J 38823. During installation, the tool will bottom out on the camshaft at the proper depth.





Notice: Refer to Fastener Notice.

3. Install the camshaft end cap.

Tighten the cap to 2 N.m (18 lb in).

4. Install the water pump drive belt.