Fuel Pressure Relief

Fuel Pressure Relief

Tools Required

J 34730-1A Fuel Pressure Gage

1. Turn the ignition OFF.
2. Disconnect the negative battery cable in order to avoid possible fuel discharge if an accidental attempt is made to start the engine.
3. Remove the fuel injector sight shield.
4. Remove the air inlet grille panel.




5. Connect the J 34730-1A to the fuel pressure valve. Wrap a shop towel around the fitting while connecting the gage in order to avoid spillage.
6. Install the bleed hose into an approved container.
7. Open the valve in order to bleed the system pressure. Fuel connections are now safe for servicing.
8. Drain any fuel remaining in the gage into an approved container.
9. Install the air inlet grille panel.
10. Install the fuel injector sight shield.
11. Connect the negative battery cable.