Seat Cushion Cover Replacement - Passenger Side

Seat Cushion Cover Replacement - Passenger Side

Removal Procedure

1. Remove the seat.




2. Remove the seat belt buckle and pretentioner from the seat frame.
3. Remove the passenger seat finish panel.
4. Remove the passenger seat rear panel bracket.




5. Remove the retaining clips which secure the cushion cover to the seat frame.
6. Remove the cover from the seat.

Installation Procedure




1. Position the trim cover over the seat cushion foam.
2. Install the cover to the seat frame.
3. Install the attaching retainers from the cover to the seat frame.
4. Install the rear flap ends together. Engage the hook and the loop.
5. Install the passenger seat rear panel bracket.
6. Install the passenger seat finish panel.






Notice: Refer to Fastener Notice.

7. Install the seat belt buckle and the pretentioner to the seat frame.

Tighten the mounting nut to 40 N.m (29 lb ft).

8. Install the seat.

Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.

9. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup.