74. OSS Sensor and Cooler Fitting Installation

OSS Sensor and Cooler Fitting Installation





1. Inspect the output speed sensor (130) for damage or a cut seal (4).
2. Inspect the cooler connector (3) for damaged threads, clogging, or a cut seal (4).





3. Install the output speed sensor (130) and the seal (4).

4. Notice:
Refer to Fastener Notice in Service Precautions.

Install the output speed sensor bolt (131).
Tighten the bolt to 8 - 14 Nm (6 - 10 ft. lbs.).
5. Install the cooler fitting (3) and the new seal (4) or fitting (38) and seal (39) into the case.
Tighten the cooler fitting to 25 - 29 Nm (19 - 21 ft. lbs.).