HVAC Control Assembly Replacement

HVAC CONTROL ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel (I/P) accessory trim plate.
2. Remove the HVAC control module assembly screws.
3. Disconnect the electrical connectors from the HVAC control module assembly.

INSTALLATION PROCEDURE




1. Connect the electrical connectors to the HVAC control module assembly.
2. Install the HVAC control module assembly into the I/P.
3. Install the HVAC control module assembly screws.

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice.

4. Install the I/P accessory trim plate.