Ignition Coil(S) Replacement - Bank 2

IGNITION COIL(S) REPLACEMENT - BANK 2

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.
2. Disconnect the ignition coil wiring harness electrical connector from the coil that is being replaced.




3. Remove the ignition coil retaining bolt.
4. Remove the ignition coil.

INSTALLATION PROCEDURE




1. Install the ignition coil.

IMPORTANT: Ensure that the spark plug seal is in place when installing the ignition coil.

2. Install the ignition coil retaining bolt.

Using the installation torque sequence, tighten the ignition module retaining bolts to 10 N.m (89 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Reconnect the ignition coil electrical connector.
4. Install the fuel injector sight shield.