Outside Temperature Display Sensor: Service and Repair

AMBIENT AIR TEMPERATURE GAGE SENSOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the knee bolster.
2. Remove the driver information center retaining screw.
3. Disconnect driver information center from the instrument panel (I/P).
4. Disconnect the inside air temperature sensor from the driver information center (DIC) bezel.




5. Disconnect the inside air temperature sensor electrical connector.

INSTALLATION PROCEDURE
1. Connect the inside air temperature sensor electrical connector.




2. Install the inside air temperature sensor.

IMPORTANT: Ensure that the inside temperature sensor is fully seated into the DIC bezel.

3. Connect driver information center to the I/P.
4. Install the driver information center retaining screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 1.9 N.m (17 lb in).

5. Install the knee bolster.