Instrument Panel Cluster (IPC) - Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the instrument panel (I/P) trim pad.
3. Carefully lift the head-up display (HUD) electrical harness from between the instrument panel cluster (IPC) and the HUD.
4. Disconnect the HUD electrical connector from the IPC.
5. Remove the IPC to steering column bracket retaining screws.
6. Raise the rear of the IPC slightly, then lift the IPC to access the electrical connector.
7. Disconnect the IPC electrical connector.
8. Remove the IPC.

INSTALLATION PROCEDURE
1. Connect the IPC electrical connector.
2. Position the IPC to the steering column bracket.




3. Install the screws which retain the IPC to the steering column bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 3 N.m (27 lb in).

4. Connect the HUD electrical connector to the IPC.
5. Install the I/P trim pad.
6. Connect the negative battery cable.

Tighten the bolt to 15 N.m (11 lb ft).