138. Power Steering Pump Installation

Power Steering Pump Installation

^ Tools Required
- J 25033-C Pulley Installer





1. Place the power steering Pump in position to the engine.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power steering Pump bolts.
^ Tighten the power steering pump bolts to 25 Nm (18 ft. lbs.).





3. If removed, place power steering pulley in position to the power steering pump.





4. Install the J25033-C into the threads of the power steering pump shaft. Ensure the J25033-C threads completely into the shaft of the power steering pump before the pressing components of the J 25033-C contact the power steering pulley.





5. Tighten the nut on the J 25033-C until the hub of the power steering pulley is flush with the end of the power steering pump shaft.
6. Remove the J 25033-C.