Convertible Top Deck Lid Position Switch / Sensor: Adjustments

FOLDING TOP COMPARTMENT LID POSITION SENSOR SWITCH ADJUSTMENT - REAR

ADJUSTMENT PROCEDURE




1. Place the folding top in the up position.
2. Open the rear compartment.
3. Place a protective covering over the interior and the adjacent body panels.




4. Loosen the screw (2) on the position sensor switch.




5. Verify that the pin (2) on the position sensor switch is positioned between the bracket (3) and the link actuator (1).
6. Adjust the position sensor switch so that the link actuator (1) depresses the pin (2).




7. Apply LOCTITE(TM) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
8. Tighten the position sensor switch screw (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screw to 2.5 N.m (22 lb in).

9. Remove the protective covering.
10. Close the rear compartment.
11. Cycle the folding top under power through one complete cycle in both directions.
12. Inspect the folding top for proper operation.