Alarm Horn: Service and Repair

THEFT DETERRENT ALARM REPLACEMENT

REMOVAL PROCEDURE




1. Open the rear compartment.
2. Disconnect the battery ground cable.
3. Loosen the screw from the theft deterrent alarm.
4. Lift the alarm from the bracket.
5. Disconnect the electrical connector and remove the alarm.

INSTALLATION PROCEDURE




1. Connect the electric connector to the theft deterrent alarm.
2. Install the alarm to the bracket.
3. Tighten the screw on the alarm.

Tighten the screw to 5 N.m (44 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Connect the battery ground cable.
5. Close the rear compartment.