3. Engine Flywheel Removal

Engine Flywheel Removal





1. Important: For manual transmission applications, note the position and direction of the engine flywheel before removal. The flywheel does not use a locating pin for alignment. Mark or scribe the end of the crankshaft and the flywheel before component removal. The engine flywheel must be installed to the original position and direction. The engine flywheel will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a 3 stage tightening process.

Mark or scribe the end of the crankshaft and the flywheel. Refer to Engine Balancing.





2. Remove the engine flywheel bolts.
3. Remove the engine flywheel.





4. Note the position and location of the manual transmission flywheel balance weights, if applicable.