Seat Back Recliner Replacement - Front

Seat Back Recliner Replacement - Front

Removal Procedure

1. Remove the seat. refer to Seat Replacement - Bucket (Seat Replacement - Bucket) .
2. Remove the seat back frame. refer to Seat Back Frame Replacement - Front (Seat Back Frame Replacement - Front) .
3. Remove the seat cushion. refer to Seat Cushion Replacement - Front (Seat Cushion Replacement - Front) .




4. Disconnect the recliner motor electrical connectors.
5. Remove the seat axle retainers (3).
6. Pull the seat track sides apart in order to separate the seat track sides.
7. Remove the nuts (1) securing the recliner to the seat track.



Installation Procedure






Notice: refer to Fastener Notice in Cautions and Notices.

1. Install the nuts (1) securing the recliner to the seat track.

Tighten the nut to 65 Nm (18 lb ft).

2. Locate the axles and the seat position drive cable (2) in order to connect the seat track sides.
Important: Insure that the seat position motor cable is fully seated into the drive gear.



3. Install the seat axle retainers (3).
4. Connect the recliner motor electrical connectors.
5. Install the seat cushion. refer to Seat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
6. Install the seat back frame. refer to Seat Back Frame Replacement - Front (Seat Back Frame Replacement - Front) .
7. Install the seat. refer to Seat Replacement - Bucket (Seat Replacement - Bucket) .
8. Calibrate the seat.