56. Control Valve Body Accumulator Assembly Assemble

Control Valve Body Accumulator Assembly Assemble

Tools Required
^ J36850 Transjel Lubricant
^ J39068 Valve Body Guide Pins





1. Install J39068 onto the front and rear control valve bodies.
2. Install the NEW control valve body spacer plate gasket (309) onto the valve bodies.
3. Install the new solenoid valve filter assemblies (308, 312) onto the control valve body spacer plate (307).
4. Install the control valve body spacer plate (307) onto the valve bodies.





5. Use J36850to install the 12 checkballs (306) onto the spacer plate (304).





6. Install the new control valve body gasket (305) onto the spacer plate (307).
7. Install the control valve body channel plate (304).





8. Use J36850 to install the control valve channel plate check ball spring (302) onto the channel plate (304).
9. Install the NEW control valve body channel plate gasket (303) onto the channel plate (304).
10. Install the control valve channel plate (301) onto the channel plate gasket (303).





Notice: Refer to Fastener Notice in Service Precautions.

11. Install the control valve body bolts (50, 300) into the valve body.
Tighten the control valve body bolts (50, 300) to 11 Nm (8 ft. lbs.).
12. Remove the J39068 from the valve body (47).





13. Install the direct clutch accumulator piston fluid seal rings (314, 316) onto the direct clutch accumulator piston (315).
14. Install the direct clutch accumulator piston (315) into the direct clutch accumulator housing (317).





15. Install the overdrive clutch accumulator piston fluid seal rings (320, 322) onto the overdrive clutch accumulator piston (321).
16. Install the overdrive accumulator piston (321) into the overdrive clutch accumulator housing (323).





17. Install the intermediate clutch accumulator fluid seal rings (325, 327) onto the intermediate clutch accumulator piston (326).
18. Install the intermediate clutch accumulator piston (326) into the intermediate clutch accumulator housing (328).





19. Install the 2nd clutch accumulator piston fluid seal rings (330, 332) onto the 2nd clutch accumulator piston (331).
20. Install the 2nd clutch accumulator piston (331) into the 2nd clutch accumulator housing (333).





21. Install the direct clutch accumulator spring (313).
22. Install the direct clutch accumulator housing (317) onto the valve body (47).
23. Install the direct clutch accumulator housing bolts (318) into the valve body (47).
Tighten the accumulator housing bolts (318) to 11 Nm (8 ft. lbs.).





24. Install the overdrive clutch accumulator spring (319).
25. Install the overdrive clutch accumulator housing (323) onto the valve body.
26. Install the overdrive clutch accumulator housing bolts (318) into the valve body.
Tighten the accumulator housing bolts (318) to 11 Nm (8 ft. lbs.).





27. Install the intermediate clutch accumulator spring (324).
28. Install the intermediate clutch accumulator housing (328) onto the valve body.
29. Install the intermediate clutch accumulator housing bolts (318) into the valve body.
Tighten the accumulator housing bolts (318) to 11 Nm (8 ft. lbs.).





Important: The 5L50-E has a unique stack-up on the 2nd clutch accumulator housing.

30. Install the 2nd clutch accumulator spring (329).
31. Install the 2nd clutch accumulator housing (333) onto the valve body.
32. Install the 2nd clutch accumulator housing bolts (318) into the valve body.
Tighten the accumulator housing bolts (318) to 11 Nm (8 ft. lbs.).