Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




- Turn the ignition OFF.
- Raise and support the vehicle. Refer to Vehicle Lifting.
- Reposition the wiring harness heat shield to obtain access.
- Disconnect the crankshaft position (CKP) electrical connector (3).




- Remove the crankshaft sensor bolt.
- Remove the crankshaft sensor.

INSTALLATION PROCEDURE




- Install the crankshaft position sensor.
- Install the crankshaft position sensor bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).




- Connect the CKP electrical connector (3).
- Install the wiring harness heat shield to the oil level indicator tube.
- Lower the vehicle.