Seat Cushion Cover and Pad Replacement - Front

Seat Cushion Cover and Pad Replacement - Front

Removal Procedure

Caution: Refer toSIR Caution in Cautions and Notices.

Important: The passenger seat is equipped with an Inflatable Restraints Passenger Presence System, which is attached to the bottom seat cushion. A preload check will have to be performed after any repairs that involve removal of the seat cover/trim.


1. Disable the SIR system. Refer toSIR Disabling and Enabling Zone 7 for driver seat and toSIR Disabling and Enabling Zone 9 for passenger seat in SIR.
2. Remove the seat cushion from the seat assembly. Refer toSeat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
3. Turn the seat cushion upside down on a clean protected surface.




4. Release the seat cushion cover J channels (1) from the seat cushion frame.




5. Remove the seat cushion cover (3) from the seat cushion frame (1).



Installation Procedure





1. Install the seat cushion (2) to the seat cushion frame (1).
2. Install the seat cushion cover (3) over the seat cushion (2).
3. Work the seat cushion cover (3) into position so there are no wrinkles or lumps in the seat cushion cover (3).
4. Ensure the hook and loop fasteners on the seat cushion cover and the seat cushion pad are fully engaged in order to ensure proper fit of the seat cushion cover (3).
5. Turn the seat cushion assembly over.




6. Install the seat cushion cover J channels (1) to the seat cushion frame.
7. Install the seat cushion to the seat assembly. Refer toSeat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
8. Enable the SIR System. Refer toSIR Disabling and Enabling Zone 7 for driver seat and toSIR Disabling and Enabling Zone 9 for passenger seat in SIR.
9. Perform the passenger presence system preload test procedure when replacing or performing any repairs on the passenger seat. Refer toControl Module References in Computer/Integrating Systems.