Ignition Coil(S) Replacement - Bank 2

IGNITION COIL(S) REPLACEMENT - BANK 2

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.
2. Remove the upper tiller panel, if necessary, to gain access to the individual coil being serviced.
3. Remove the ignition coil cover from the cam cover by lifting straight up, if equipped.
4. Disconnect the ignition coil wiring harness electrical connector from the coil that needs to be replaced.
5. Remove the ignition coil retaining bolt.
6. Carefully remove the ignition coil assembly.




7. If removal of all the coils are necessary, disconnect the main coil wiring harness at the cam cover.




8. Remove the coil assembly bolts and studs.
9. Carefully remove the ignition coil assembly.

INSTALLATION PROCEDURE




1. Carefully install the ignition coil assembly. Ensure that the spark plug seals are in position.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the ignition coil assembly retaining bolts and studs.

Tighten
Tighten the ignition coil assembly retaining bolts and studs to 10 Nm (89 lb in).




3. Connect the main coil wiring harness at the cam cover.

IMPORTANT: Ensure that the spark plug seals are in place when installing the ignition coil.




4. Install the ignition coil.
5. Install the ignition coil retaining bolt.

Tighten
Tighten the ignition coil retaining bolt to 10 Nm (89 lb in).

6. Reconnect the ignition coil electrical connector.
7. Install the ignition coil cover to the cam cover.
8. Install the upper filler panel, if removed during disassembly.
9. Install the fuel injector sight shield.