Instrument Panel (IP) - Accessory Trim Plate Replacement - Right Side (Rhd)

TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY RIGHT (RHD)

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the instrument panel (I/P) upper trim pad.
3. Remove the I/P cluster trim panel.
4. Remove the screw near the I/P cluster at the I/P retainer.
5. Pull rearward on the trim panel in order to disengage the three retainers, and remove the trim plate.

INSTALLATION PROCEDURE




1. Align the trim panel to the I/P retainer.
2. Push forward on the trim plate in order to engage the three retainers, while aligning the A/C housing with the A/C ducts.
3. Install the screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2 N.m (18 lb in).

4. Install the I/P cluster trim panel.
5. Install the I/P upper trim pad.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in Restraint Systems.