Head Up Display Module Replacement
HEAD UP DISPLAY MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the instrument panel upper trim pad.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Remove the fasteners (3) from the head up display module (HUD) (1).
3. Disconnect the electrical connector (2) from the HUD module.
4. Remove the HUD module (1) from the instrument panel.
INSTALLATION PROCEDURE
1. Connect the electrical connector (2) to the head up display module (HUD) (1).
2. Install the HUD module (1) to the instrument panel.
3. Install the fasteners (3) into the HUD module (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 2 N.m (18 lb in).
4. Install the instrument panel upper trim pad.