Instrument Panel (IP) - Accessory Trim Plate Replacement - Left Side (LHD)

Trim Plate Replacement - Instrument Panel (I/P) Accessory Left (LHD)

Removal Procedure





Caution: Refer to SIR Caution.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5.
2. Remove the instrument panel (I/P) upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Service and Repair).
3. Remove the I/P cluster trim panel. Trim Panel Replacement - Instrument Panel (I/P) Cluster (Instrument Panel Cluster (IPC) - Trim Panel Replacement).
4. Remove the screw near the I/P cluster at the I/P retainer.
5. Lift the outboard end of the trim plate in order to disengage the locating tab, then pull the trim plate rearward.



Installation Procedure





1. Align the trim panel with the I/P retainer.
2. Push forward on the trim plate in order to engage the three retainers, while aligning the A/C housing with the A/C ducts.

Notice: Refer to Fastener Notice.

3. Install the screws.

Tighten the screws to 2 N.m (18 lb in).

4. Install the I/P cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster (Instrument Panel Cluster (IPC) - Trim Panel Replacement).
5. Install the instrument panel (I/P) upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Service and Repair).
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5.