Rear Position Sensor Replacement

Rear Position Sensor Replacement Electronic Suspension

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector (1) from the vehicle harness connector.
4. Disconnect 3 sensor harness clips from the vehicle.





5. Disconnect the sensor link (1) from the control arm ball stud (2).





6. Remove the nut (1) that retains the position sensor (2) to the vehicle.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the position sensor (2) on the vehicle with the retainer nut (1).
^ Tighten the nut to 15 Nm (11 ft. lbs.).





2. Connect the sensor link (1) to the control arm ball stud (2).
3. Connect the three sensor harness clips onto the vehicle.





4. Connect the sensor harness connector (1) to the vehicle harness connector.
5. Install the wheel onto the vehicle.
6. Lower the vehicle.
7. Perform trim height adjustment.
8. If equipped with the F55 suspension, use the scan tool in order to perform the Bump Stop Trim Set procedure.