Engine Ground Strap Replacement

Engine Ground Strap Replacement

Removal Procedure






1. Remove the fuel injector sight shield, if necessary.






2. Remove the ignition control module (ICM) ground strap bolt (3) from the cylinder head.
3. Loosen the ICM ground strap bolt (1) from the camshaft cover.
4. Remove the ICM ground strap (2).






5. Remove the ICM ground strap bolt (3) from the cylinder head.
6. Loosen the ICM ground strap bolt (1) from the camshaft cover.
7. Remove the ICM ground strap (2).

Installation Procedure






1. Install the ICM ground strap (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Tighten the ICM ground strap bolt (1) to the camshaft cover.

Tighten
Tighten the bolt to 10 Nm (89 lb in).

3. Install the ICM ground strap bolt (3) to the cylinder head.

Tighten
Tighten the bolt to 25 Nm (18 lb ft).






4. Install the ICM ground strap (2).
5. Tighten the ICM ground strap bolt (1) to the camshaft cover.

Tighten
Tighten the bolt to 10 Nm (89 lb in).

6. Install the ICM ground strap bolt (3) to the cylinder head.

Tighten
Tighten the bolt to 10 Nm (89 lb in).






7. Install the fuel injector sight shield, if necessary.