Instrument Panel (IP) - Insulator Panel Replacement - Left Side (RHD)

Instrument Panel Insulator Panel Replacement - Left Side (RHD)

Removal Procedure





1. Remove the fasteners (1) at the rear edge of the insulators.
2. Push in on the snap tab retainers in order to release the insulator.




3. Disconnect the electrical connectors (1,2) as necessary.
4. Slide the insulator (3) rearward toward the vehicle.



Installation Procedure





1. Set the forward edge of the insulator onto the shelf on the carpeting at the front of the vehicle.
2. Reconnect the electrical connectors (1,2).




3. Align the insulator with the floor duct at the HVAC module.
4. Align the snap tab fasteners with the lower IP, and push the panel upward in order to engage the fasteners.

Notice: Refer to Fastener Notice.

5. Install the insulator fasteners (1) into the lower IP.

Tighten the fasteners to 2 N.m (18 lb in).