Instrument Panel (IP) - Accessory Trim Plate Replacement - Right Side (LHD)

Instrument Panel Accessory Trim Plate Replacement - Right Side (LHD)

Removal Procedure
Caution: Refer to SIR Handling Caution.





1. Disable the SIR system. Refer to Disabling the SIR System.
2. Remove the IP (Instrument Panel) upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement (Service and Repair).
3. Remove the IP cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement (Instrument Cluster Trim Panel Replacement).
4. Remove the screws from the accessory trim panel.
5. Remove the PSIR module. Refer to Inflatable Restraint Instrument Panel Module Replacement.




6. Remove the two screws from the straps at the carrier.
7. Pull rearward on the trim panel in order to disengage the three retainers, and remove the trim plate.



Installation Procedure





1. Align the trim panel with the IP retainer.
2. Push forward on the trim plate in order to engage the three retainers, while aligning the A/C housing with the A/C ducts.

Notice: Refer to Fastener Notice.

3. Install the screws to the accessory trim panel.

Tighten the screws to 2 N.m (18 lb in).





4. Install the screws through the straps to the carrier.

Tighten the screws to 2 N.m (18 lb in).

5. Install the IP cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement (Instrument Cluster Trim Panel Replacement).
6. Install the PSIR module. Refer to Inflatable Restraint Instrument Panel Module Replacement.
7. Install the IP upper trim pad.
8. Enable the SIR. Refer to Enabling the SIR System.