Instrument Panel (IP) - Accessory Trim Plate Replacement - Left Side (LHD)

Instrument Panel Accessory Trim Plate Replacement - Left Side (LHD)

Removal Procedure
Caution: Refer to SIR Handling Caution.





1. Disable the SIR system. Refer to Disabling the SIR System.
2. Remove the IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement (Service and Repair).
3. Remove the IP cluster trim panel. Instrument Cluster Trim Panel Replacement (Instrument Cluster Trim Panel Replacement).
4. Remove the screw near the IP cluster at the IP retainer.
5. Lift the outboard end of the trim plate in order to disengage the locating tab, then pull the trim plate rearward.



Installation Procedure





1. Align the trim panel with the IP retainer.
2. Push forward on the trim plate in order to engage the three retainers, while aligning the A/C housing with the A/C ducts.

Notice: Refer to Fastener Notice.

3. Install the screws.

Tighten the screws to 2 N.m (18 lb in).

4. Install the IP cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement (Instrument Cluster Trim Panel Replacement).
5. Install the IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement (Service and Repair).
6. Enable the SIR system. Refer to Enabling the SIR System.