Coil Spring Replacement (FE1, FE3)

- Tools Required
- J 24319-B Universal Steering Linkage Puller

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and the wheel.
3. Support the lower control arm with a suitable jack.
4. Remove the automatic level control link from the lower control arm.
5. Remove the shock absorber lower retaining bolts.





6. Remove the adjustment link retaining nut.
7. Using J 24319-B separate the adjustment link from the lower control arm.





8. Slowly lower the lower control arm until it bottoms on the support assembly.
9. Remove the coil spring.

Installation Procedure





1. Install the coil spring ensuring the insulator is seated in the lower control arm.

Notice: Refer to Fastener Notice in Service Precautions.





2. Raise the lower control arm and install the shock absorber lower retaining bolts.
- Tighten the shock absorber lower retaining bolts to 25 Nm (18 ft. lbs.).





3. Install the adjustment link to the control arm.
4. Install the adjustment link retaining nut.
- Tighten the adjustment link retaining nut to 30 Nm (22 ft. lbs.) then tighten an additional 180 degrees.
5. Connect the automatic level control link to the lower control arm.
6. Install the tire and wheel.
7. Lower the vehicle.