Starter Motor: Service and Repair
STARTER MOTOR REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the battery negative cable.
2. Remove the intake manifold.
3. Disconnect the BAT cable from the starter.
4. Disconnect the wire from the "S" terminal on the starter.
5. Remove the two starter motor mounting bolts.
6. Remove the starter motor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Connect the starter motor "S" terminal wire.
Tighten
Tighten the starter solenoid S terminal nut to 4 N.m (35 lb in).
2. Connect the starter motor BAT terminal wire.
Tighten
Tighten the battery cable to starter terminal nut to 10 N.m (89 lb in).
3. Install the starter motor.
4. Install the starter motor mounting bolts.
Tighten
Tighten the starter motor mounting bolts to 30 N.m (22 lb ft).
5. Install the intake manifold.
6. Connect the battery negative cable.