Turn Signal Flasher: Service and Repair

HAZARD AND TURN SIGNAL FLASHER REPLACEMENT

The turn signal/warning lamp flasher is located in the convenience center behind the I/P driver knee bolster energy absorber directly below the steering column.

Removal Procedure




1. Remove the self-locking screws from the I/P driver knee bolster energy absorber.
2. Slide the I/P driver knee bolster energy absorber upward to release the I/P driver knee bolster energy absorber from the tabs.
3. Remove the I/P driver knee bolster energy absorber




4. Remove the turn signal/warning lamp flasher (6) from the convenience center.

Installation Procedure




1. Install the turn signal/warning lamp flasher (6) to the convenience center.




2. Slide the I/P driver knee bolster energy absorber downward to secure the I/P driver knee bolster energy absorber to the tabs to install the I/P driver knee bolster energy absorber.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the self-locking screws to the I/P driver knee bolster energy absorber.

Tighten
Tighten the self-locking screws to 2 N.m (18 lb in).