Oil Pick Up/Strainer: Service and Repair

Oil Pump Pipe and Screen Assembly
Replacement

Removal Procedure





1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Drain the engine oil.
4. Remove the lower oil pan.
5. Remove the oil intake pipe bolts.
6. Remove the oil intake pipe.
7. Remove the oil intake pipe O-ring.
8. Clean the sealing surfaces.

Installation Procedure





1. Install the oil intake pipe O-ring.
2. Install the oil intake pipe.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the oil intake pipe bolts.
Tighten the oil intake pipe bolts to 8 Nm (71 inch lbs.).
4. Install the lower oil pan.
5. Lower the vehicle.
6. Fill the crankcase with engine oil.
7. Connect the negative battery cable.